New pin in, all back together. Still slight issue,, n this may be where all the trouble started. The table movbes to the operators side,,,left to right if facing the machine fine. but if going the other way ,,the ratchet pawl slips over the teeth,,,with much protesting noise. Tried it a coupla times ,,,might move through several cycles the same thging. The table is noticeably harde to move away,,,towards the left. Even using a wrench,,,no crank handle with machine.Soooooo, I left it ,,I'll have a think on why is harder to move one way than other,, n get back on it next week. Off to the city for Dr appointments n such now