| Gallery, Projects and General > Project Logs |
| Coke Forge Build |
| << < (2/53) > >> |
| RobWilson:
--- Quote from: Arbalist on February 15, 2015, 07:01:59 AM ---Half inch plate plate is fairly common on builds over on IForgeIron, some folks prefer 5/8" though! :D --- End quote --- Did you make yours in 5/8" plate ? any photos :poke: Rob |
| RobWilson:
Next up , the fire pot needs to be fit to the hearth :dremel: I designed the fixings so that the fire pot could float , to allow for expansion/contraction . Rob |
| Manxmodder:
Tremendous stuff Rob,glad to see you back posting projects up here. :thumbup:......OZ. |
| RobWilson:
Hi there OZ and thanks :beer: Next up the blower , I was going to use this motor as I had it on the shelf .(and me being a cheep skate ) :) But down to overwhelming pressure form other interweb users who will remain nameless ( he keeps sheep in East Sussex ) :) ,this being the wrong motor for the job , he being correct of course :bang: I splashed out and bought a new motor . :med: Blower case is made from a sheet of 1.5mm semi stainless (sounds like bollocks to me ) but that what i was told it was , any way I got a load from a car exhaust factory . Machined up a few inserts The strip was then rolled in my CNC rollers Next up I poked a hole in each side . The way I have designed the fan casing I can have the output in any orientation I desire . Rob |
| CrazyModder:
Very awesome job, my mate. :drool: This is one reason I hate living in a, while large enough, yet still rented house. I can't just go ahead and convert a corner of the garage into a "dirty" place. :bang: |
| Navigation |
| Message Index |
| Next page |
| Previous page |