Gallery, Projects and General > Mod-Ups!

Pipe and Bolt Engine Mod-Up

<< < (17/50) > >>

vtsteam:
Drilled for the crank:

vtsteam:
And assembled it to the crank. It took a little touch up with a file to remove any sticking points and in a short time it was working nicely. Done for the day,  :dremel:

dsquire:
Steve

I see that you have just about got this one nailed.  :Doh:  :D :D

Cheers  :beer:

Don

vtsteam:
Tacky, Don! :ddb:

  :palm:
:beer:

shipto:
I too managed a little time in the shed today and made a flywheel. I took some tube and started working it in my circle turner before trimming it down to join the two ends (i really should get my oxygen bottle filled so I can braze its been empty for a while now but anyway) then 3 more bits of tube for the spokes and a bolt and i have a rather bigger than wanted flywheel but the circle turner is meant for flat stock so I was happy it did the job at all.
I could not find a bolt the stated size so I hope it wont be classed as cheating if I use a bit of bar the right size to make up the difference?

Navigation

[0] Message Index

[#] Next page

[*] Previous page