| Gallery, Projects and General > Mod-Ups! |
| Pipe and Bolt Engine Mod-Up |
| << < (16/50) > >> |
| vtsteam:
Then I sawed off the excess: |
| vtsteam:
What it looked like: |
| vtsteam:
Turned it upside down in the drill vise, marked out and drilled through w/tapping drill for 4-40 screws. |
| vtsteam:
Then sawed it off to split bearing: |
| vtsteam:
Drilled cap for clearance, countersung, and then tapped one side of the big end. Then replaced the cap, screwed it down and tapped through the other side as a guide: |
| Navigation |
| Message Index |
| Next page |
| Previous page |