| Gallery, Projects and General > Mod-Ups! |
| Pipe and Bolt Engine Mod-Up |
| << < (17/50) > >> |
| vtsteam:
Drilled for the crank: |
| vtsteam:
And assembled it to the crank. It took a little touch up with a file to remove any sticking points and in a short time it was working nicely. Done for the day, :dremel: |
| dsquire:
Steve I see that you have just about got this one nailed. :Doh: :D :D Cheers :beer: Don |
| vtsteam:
Tacky, Don! :ddb: :palm: :beer: |
| shipto:
I too managed a little time in the shed today and made a flywheel. I took some tube and started working it in my circle turner before trimming it down to join the two ends (i really should get my oxygen bottle filled so I can braze its been empty for a while now but anyway) then 3 more bits of tube for the spokes and a bolt and i have a rather bigger than wanted flywheel but the circle turner is meant for flat stock so I was happy it did the job at all. I could not find a bolt the stated size so I hope it wont be classed as cheating if I use a bit of bar the right size to make up the difference? |
| Navigation |
| Message Index |
| Next page |
| Previous page |