Gallery, Projects and General > Project Logs |
Tiny Vertical Based On G. Britnell's Design |
<< < (14/18) > >> |
Stilldrillin:
WOW!! :bugeye: That's a little cracker, Stew! :thumbup: Blummin, well done! :clap: :clap: David D |
vtsteam:
Wonderful work! :thumbup: :thumbup: :clap: :clap: |
mexican jon:
Brilliant :thumbup: Well done that man :headbang: :headbang: |
modeldozer:
Well done. :clap: :clap: :clap: :bow: :beer: Abraham |
sbwhart:
Thanks for your interest and comments lads I've been doing a fair bit of tinkering with it this last week as I wasn't getting a consistent running out of it, I tweak this and that, then I thought I wonder if it will run without the valve guide as its not really doing anything and it was tightening things up so I took it off and wow what a change. What with all my tinkering I'd broken off some of the M1 screws in the valve chest :cussing: so I decided to make a new one with no provision for the guide and with a M2.5 inlet port instead of the flange inlet arrangement I was using. So heir's a video of the improved run, I didn't check the RPM as the battery on my taco was flat, I'll check that tomorrow and get back to you on its speed. Now that I'm happy with how it runs:- I'm going to add a bit of Glam. For this I've made a tiny stop valve that I will plumb into the wooden base. Stew |
Navigation |
Message Index |
Next page |
Previous page |