Gallery, Projects and General > Project Logs
Tiny Vertical Based On G. Britnell's Design
<< < (13/18) > >>
Stilldrillin:
Stew.

Sounds like your little bit of clearances, are getting in the road........  :lol:

Good luck, with the tightening process!  :thumbup:

David D
sbwhart:
 :lol: :lol: :lol:

Yes its a case of too much clearance getting in the way.

I think I failed to appreciate the small size effect on clearance:- 0.1mm clearance on a 10mm shaft is 1% but 0.1mm clearance on a 1mm shaft is 10% magnify that by each bit of linkage and you lose a lot of movement.

 :doh:

Still it keeps the old grey cells working.

I've just got to get a bit more precision into the job  :hammer:

Stew
Stilldrillin:

--- Quote from: sbwhart on January 25, 2015, 03:24:22 AM --- I've just got to get a bit more precision into the job  :hammer:

--- End quote ---

Nah!

Just remod, the modded cam. To give 1.5mm throw.........  :thumbup:

David D
sbwhart:

--- Quote from: Stilldrillin on January 25, 2015, 04:14:10 AM ---
--- Quote from: sbwhart on January 25, 2015, 03:24:22 AM --- I've just got to get a bit more precision into the job  :hammer:

--- End quote ---

Nah!

Just remod, the modded cam. To give 1.5mm throw.........  :thumbup:

David D

--- End quote ---

That's Plan B and eccentric eccentric

 :D

HE HE HE don't need plan B

Made some closer fitting pins and took out a fouling point on the linkage.

That's got it sorted, you need to keep your finger on the handle but I can sort that and it runs in both direction.

 :nrocks: :nrocks: :nrocks:

 :ddb: :ddb: :ddb: :ddb:

 :headbang:







I'm a little chuffed at that

Stew
RussellT:
Tht's nice.  :clap:

Russell
Navigation
Message Index
Next page
Previous page

Go to full version