« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Oh dear. Milling machine incoming  (Read 11613 times)

Offline Swarfing

  • Sr. Member
  • ****
  • Posts: 417
  • Country: gb
Re: Oh dear. Milling machine incoming
« Reply #25 on: November 05, 2014, 03:59:54 PM »
You should find it is the same setup as viceroy believe with a twin belt. There is no reason though not to be able to set it up as vertical with an all in one head.

Sending you a PM
Logged
Once in hole stop digging.
Pages: 1 [2]  All   Go Up
« previous next »