« previous next »
Pages: [1]   Go Down

Author Topic: Off-set centers  (Read 4995 times)

Offline Darren

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 3795
  • N/Wales
Off-set centers
« on: April 07, 2009, 11:54:11 AM »
Can someone please explain what a pair of off-set centers are on a lathe,

I know what centers are, but how do you off-set them  :scratch:

I would assume centers where centered and the work was off-set on the centers being driven by a dog?
Logged
You will find it a distinct help… if you know and look as if you know what you are doing. (IRS training manual)

Offline Stilldrillin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4972
  • Country: gb
  • Staveley, Derbyshire. England.
Re: Off-set centers
« Reply #1 on: April 07, 2009, 12:48:15 PM »
Dunno!  :scratch:

Crankshaft throws are turned between a pair of offset centre holes.......  ::)

David D
Logged
David.

Still drilling holes... Sometimes, in the right place!

Still modifying bits of metal... Occasionally, making an improvement!

Offline Darren

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 3795
  • N/Wales
Re: Off-set centers
« Reply #2 on: April 07, 2009, 02:34:19 PM »
Thanks David, I thought as much.

Was thrown by some text I was reading earlier.

Ta... :thumbup:
Logged
You will find it a distinct help… if you know and look as if you know what you are doing. (IRS training manual)

Offline Stilldrillin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4972
  • Country: gb
  • Staveley, Derbyshire. England.
Re: Off-set centers
« Reply #3 on: April 08, 2009, 01:55:05 AM »
Yer welkum!  :wave:


JUST read your Twin Cyl engine post.  ::)

Good luck!  :thumbup:

David.
« Last Edit: April 08, 2009, 03:31:10 AM by Stilldrillin »
Logged
David.

Still drilling holes... Sometimes, in the right place!

Still modifying bits of metal... Occasionally, making an improvement!
Pages: [1]   Go Up
« previous next »