« previous next »
Pages: [1]   Go Down

Author Topic: Anyone around here run a large horizontal mill?  (Read 25 times)

Offline BillTodd

  • Hero Member
  • *****
  • Posts: 1191
  • Colchester Essex (where the lathes were made)
Anyone around here run a large horizontal mill?
« on: Today at 12:35:58 PM »
I have just acquired a large number of horizontal milling cutters. Many are way too big for my Haighton mill.

So, anyone run a mill capable of spinning 5 and 6 " cutters upto an inch wide?
Logged
Bill
Pages: [1]   Go Up
« previous next »