« previous next »
Pages: [1]   Go Down

Author Topic: Spot the mistake  (Read 28559 times)

Offline Dell

  • Jr. Member
  • **
  • Posts: 96
    • anniversary-clocks.co.uk
Spot the mistake
« on: March 24, 2023, 10:28:50 AM »
I have been getting used to using my new to me lathe , I had already made a mount so I can use the graver, and I thought next I would make a carriage stop but it needed to be a stop and a mount for the dial gauge well I was chuffed that what I had made was going to do the job until I fitted the dti  :doh: the carriage hits the mount before the full travel of the dti , so a slight modification is needed.
Dell
 [attachment id=0 msg=164099]  [attachment id=1 msg=164099]  [attachment id=2 msg=164099]
Logged
Old man but still learning

Offline awemawson

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 9054
  • East Sussex, UK
Re: Spot the mistake
« Reply #1 on: March 24, 2023, 10:42:40 AM »
He who's never made a mistake has never made anything !

. . . . it's all a learning exercise  :thumbup:
Logged
Andrew Mawson
East Sussex

Offline AdeV

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2456
Re: Spot the mistake
« Reply #2 on: March 24, 2023, 12:51:34 PM »
Could you make an extension for the DI plunger? Might be the easiest fix...
Logged
Cheers!
Ade.
--
Location: Wallasey, Merseyside. A long way from anywhere.
Occasionally: Zhengzhou, China. An even longer way from anywhere...

Offline Dell

  • Jr. Member
  • **
  • Posts: 96
    • anniversary-clocks.co.uk
Re: Spot the mistake
« Reply #3 on: March 24, 2023, 04:01:21 PM »
Yes AdeV
That was my thinking as extended pointers are freely available, although I could make one.
Logged
Old man but still learning

Offline krv3000

  • Hero Member
  • *****
  • Posts: 2188
Re: Spot the mistake
« Reply #4 on: June 10, 2023, 03:09:26 PM »
 hi a job well dune just make a extension  regards bob
Logged
Pages: [1]   Go Up
« previous next »