Author Topic: Howdy from Bellingham, WA  (Read 3386 times)

Offline lobocnc

  • Newbie
  • *
  • Posts: 3
  • Country: us
    • Lobo CNC Open Source Milling Machine Project
Howdy from Bellingham, WA
« on: February 13, 2013, 02:14:49 PM »
Hi All, I'm a mechanical engineer that drifted into electronics and software.  Now I'm getting back into more mechanical design and building things.  I've a lot of experience with motor control, and have done a handfull of CNC machines - from scratch and retrofits.  Currently, I'm trying to get a new open-source, DIY CNC milling machine project off the ground (see lobocnc.com), but I'll do a proper post about that in the Tools section.  Look forward to seeing what you all are up to.

Offline saw

  • Hero Member
  • *****
  • Posts: 1003
  • Country: se
  • lucky amateur
    • Svenssons AckordsWerkstad
Re: Howdy from Bellingham, WA
« Reply #1 on: February 13, 2013, 02:26:20 PM »
Hi and welcome to us  :wave:
_________________________
Greetings / Benni
http://myprojecty.wordpress.com/category/steam-engine/

Offline krv3000

  • Hero Member
  • *****
  • Posts: 2185
  • Country: gb
Re: Howdy from Bellingham, WA
« Reply #2 on: February 13, 2013, 06:29:20 PM »
Welcome to the collective

Offline AussieJimG

  • In Memoriam
  • Sr. Member
  • *****
  • Posts: 381
  • Country: au
Re: Howdy from Bellingham, WA
« Reply #3 on: February 13, 2013, 10:31:01 PM »
Welcome to the forum

Jim