im needing a worm gear for the dividing head iv cast so thought id have a go at hobbing a 72T gear with a 3/4 BSw 10TPI tap
after doing a lot of reading online and a lot of calculations I thought I had the method worked out and went with the following calcs (in imperial)
DP = Pi/(1/TPI) =PI*1 = 31.4159
Diameter = T+3/DP = 75/31.4159 = 2.38732414638
I double checked this by using a circular pitch of 10, to give a pitch diameter of 2.291. add 2x tooth depth (0.060?) = 2.411, seems close enough.
so I cut off a lump of bar and turned it to 2.387'' marked out and gashed at 5 degrees with a hacksaw for 72 teeth.
![](http://i655.photobucket.com/albums/uu280/b-bassett/WP_20151004_001_zpspfmqbdhd.jpg)
put it on the shaft of the dividing head and with the tap in a collet fired things up
![](http://i655.photobucket.com/albums/uu280/b-bassett/WP_20151004_003_zpsrmga46wh.jpg)
![](http://i655.photobucket.com/albums/uu280/b-bassett/WP_20151004_007_zps7anbboew.jpg)
turned nicely and pretty soon I had a nice set of teeth.
problem is there were 4 to many
![Doh :Doh:](https://madmodder.net/Smileys/default/Doh.gif)
so I turned the lump down and tried for a 60T, ended up with 66
so I tried for 45 - without gashing - got 44
so I then just kept pushing the blank in to see what would happen, ended up with 35
![:doh:](https://madmodder.net/Smileys/default/doh-45.gif)
so before I cut up another bit of ally what am I doing wrong??