« previous next »
Pages: 1 [2]  All   Go Down

Author Topic: Newest Member to the Atlas Shaper club  (Read 24826 times)

Offline Powder Keg

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 932
  • Machinist Extraordinaire
Re: Newest Member to the Atlas Shaper club
« Reply #25 on: October 03, 2010, 09:00:54 PM »
Well, Today I managed to get my table extension painted and installed\o/ It turned out pretty nice. But I forgot to take a picture, so you'll have to wait for that.

I also turned up a tool holder to hold a piece of 5/16" round HSS. (an old center drill) It has a flange on the back to keep it from going through the clapper on the shaper. Then the washer that I made and a 1" - 14 TPI jam nut tightens it onto the clapper. I need to mill a couple of flats on the nose so I can tighten it and drill 3-4 set screw holes to hold the tool in. I also need to grind up a couple of tool bits. I wish I had my surface grinder fixed....

http://img.photobucket.com/albums/v652/Powderkeg3418/Atlas%20Shaper/Atlas010.jpgNewest Member to the Atlas Shaper club
http://img.photobucket.com/albums/v652/Powderkeg3418/Atlas%20Shaper/Atlas011.jpgNewest Member to the Atlas Shaper club

I'll get some pictures of the painted extension soonhttp://img.photobucket.com/albums/v652/Powderkeg3418/Smilies/jumping0032.gifNewest Member to the Atlas Shaper clubhttp://img.photobucket.com/albums/v652/Powderkeg3418/Smilies/jumping0032.gifNewest Member to the Atlas Shaper clubhttp://img.photobucket.com/albums/v652/Powderkeg3418/Smilies/jumping0032.gifNewest Member to the Atlas Shaper club
« Last Edit: October 03, 2010, 09:10:47 PM by Powder Keg »
Logged
Wesley P
A Gismo ??? If it has a flywheel or spins and is made with small parts. I'll take one! If it makes noise, moves, or requires frequent oiling and dusting it's a better deal yet. It's especially right if its shiny and bright; but if it's dirty and dull it wont mater at all...
Pages: 1 [2]  All   Go Up
« previous next »