MadModder

The Shop => Tools => Topic started by: doubleboost on August 09, 2013, 09:10:18 PM

Title: Pin Chuck
Post by: doubleboost on August 09, 2013, 09:10:18 PM

John

Title: Re: Pin Chuck
Post by: S. Heslop on August 10, 2013, 07:34:01 AM

That's a good bit of info with the taper shank drills. You tend to always find a few at a car boot sale.

I still need to get ahold of a decent pin chuck myself. Back when I was making a burner orifice I went all out and bought an official genuine English made Eclipse pin chuck and it was a total piece of junk. The drills were wobbling a full millimeter off centre.

Title: Re: Pin Chuck
Post by: micktoon on August 10, 2013, 11:27:19 AM

Hi John , another good video and useful tool made fromm worn out gear ...............keep up the good work  :bow: :thumbup:

Cheers Mick

Title: Re: Pin Chuck
Post by: dbs on August 12, 2013, 08:08:49 PM

Good video John,
I should have made one of those instead of buying a "Micro Drill Adaptor" from  ARCEUROTRADE.  Looked like it would be handy in the drill press but it wobbles like an old wagon wheel.
Like your videos, keep them coming.  Dave

Title: Re: Pin Chuck
Post by: vtsteam on August 12, 2013, 08:48:44 PM

Cool!  :beer:

Title: Re: Pin Chuck
Post by: Anzaniste on August 12, 2013, 09:37:10 PM

I was just about to make a morse taper centre for my rotary table when I was saved by your brilliantly simple suggestion. Thank you John..