MadModder
The Shop => Tools => Topic started by: Meldonmech on September 14, 2012, 10:50:59 AM
-
HI Guys
These little toggle clamps I use for fine and delicate work holding when using the small sensitive drilling machine 1/4 max. capacity. Each clamp has a different foot and these cover the majority of work I do on small irregular shaped components. The hand held assembly sits on the machine table. A hard wood block used to support the work is tacked in position, this helps to reduce burrs when the drill breaks through. The feet can have card, leather or plastic soles glued on to protect the work.
Cheers David
-
Hi David, They look like handy little gadgets :thumbup:, thanks for posting. I can think of a good few times where I would have used one , so its another thing on the to do list :palm: ...... I just hope I am going to live to 100 years old or not everything on this list is going to get done :lol:
Cheers Mick
-
Hi Mick
Thanks for your comments, I always make workshop, tools and machinery mods between projects, all three clamps
only took a couple of hours to make, but have saved me many hours.
Cheers David