MadModder

Home Base => Introductions => Topic started by: luky luke on August 08, 2012, 05:54:10 AM

Title: Hello from France ...!
Post by: luky luke on August 08, 2012, 05:54:10 AM

Hello,

I am on the Forum HMEM, and it is reading the pages I found a link on this forum, I know I am registered for the month of February, and it is only now that I officially introduce myself, so I ask you all to forgive me, I'll try to show active both here and on HMEM.
I have projects in mind, the problem is that as I would not have finished the retrofit of my CNC milling machine, I can not do the things I planned to do otherwise, but I arrive at final aim.

I wish you all much success in your future and current projects.

Pray for me for the CNC, I'm a veritable Pumpkin in electronics, I must yet to go however by that.
I have already burnt a card-Board (cnc4pc), brief...

When this is over and operational, I do a post with a video on YouTube and a link.

Cordially,
J-M   :beer: 

Title: Re: Hello from France ...!
Post by: saw on August 08, 2012, 06:33:26 AM

Hi and feel very welcome to us  :wave:

Title: Re: Hello from France ...!
Post by: spuddevans on August 08, 2012, 06:38:44 AM

Well hello and welcome  :thumbup: We're glad to have you here with us, and look forward to seeing some of what you are doing.


Tim

Title: Re: Hello from France ...!
Post by: PekkaNF on August 08, 2012, 07:52:19 AM

Wellcome!

Where from France? I asume it's not Paris, because it gets mentioned over France. Hope it's classic food/vine region.

Post your stuff, even if it is not ready.

PekkaNF

Title: Re: Hello from France ...!
Post by: Brass_Machine on August 08, 2012, 10:53:48 PM

Bonjour!  :wave:

Welcome to the collective :borg:

What kind of mill are you converting to CNC? I tried to put together a controller board (hobby CNC), burnt it up, then bought one of the chinese TB boards and then just finally got a decent controller. Spent more money that way than if I had just bought a nice Gecko setup...

Eric


**hopefully I get this right...

Quel genre de moulin à vous convertir au CNC? J'ai essayé de mettre sur pied une carte contrôleur (hobby CNC), elle a brûlé en place, puis acheté l'un des conseils de tuberculose chinois et puis juste a finalement obtenu un contrôleur décent. Dépensé plus d'argent de cette façon que si je venais d'acheter une configuration belle Gecko ...

Title: Re: Hello from France ...!
Post by: krv3000 on August 09, 2012, 02:31:37 AM

hi jump in and have fun

Title: Re: Hello from France ...!
Post by: AussieJimG on August 12, 2012, 12:38:18 AM

Welcome. I hope you enjoy the site.

Jim