MadModder

The Shop => Tools => Topic started by: doubleboost on January 04, 2012, 05:02:59 PM

Title: Mill Vice
Post by: doubleboost on January 04, 2012, 05:02:59 PM
Hi
Being going to do this for ages now
(http://i261.photobucket.com/albums/ii63/john970s0/P1040035.jpg)
(http://i261.photobucket.com/albums/ii63/john970s0/P1040038.jpg)
(http://i261.photobucket.com/albums/ii63/john970s0/P1040040.jpg)
John
Title: Re: Mill Vice
Post by: Rob.Wilson on January 04, 2012, 05:10:19 PM
Aboot time you got your arse in gear mate  :lol: :lol: :lol: :lol:

Nice screw jacks  :med:

Rob
Title: Re: Mill Vice
Post by: doubleboost on January 04, 2012, 05:14:08 PM
The old bloke i got them from would be very happy to see them used
John
Title: Re: Mill Vice
Post by: DaveH on January 04, 2012, 05:42:52 PM
John,

ermmmm ............. do what?
 :beer:
DaveH
Title: Re: Mill Vice
Post by: doubleboost on January 04, 2012, 05:50:42 PM
Dave
You machine a block to be a perfect fit in the table slots
Grip it with the vice
Machine a slot in the vice base then fasten the block in to the machined slot
Vice then will be located square to the table (been shown hear many times)
John
Title: Re: Mill Vice
Post by: DaveH on January 04, 2012, 06:28:25 PM
John,

Sorry John, I was pulling your leg :Doh:

"going to do this for ages now"
The slot in the underside of the vice is already there :) :) :)

 :palm: :palm: :palm: :palm: :palm:

Sorry I just have a strange sense of humour.

Some days, especially today I should have just stayed in bed.
 :beer:
DaveH