MadModder

The Shop => Tools => Topic started by: No1_sonuk on May 09, 2011, 10:33:08 AM

Title: Sieg X3 Table X-Axis End Plate Dimensions
Post by: No1_sonuk on May 09, 2011, 10:33:08 AM
Does anyone have a dimensioned drawing of the Sieg X3 X-axis left-hand end plate?
Particularly the points related to the factory power feed.

I'm planning on building a power feed (with a stepper) for my shiny new mill, and would rather not spend the time working it out if someone else already has.

Thanks.
Title: Re: Sieg X3 Table X-Axis End Plate Dimensions
Post by: lordedmond on May 09, 2011, 10:40:28 AM
where are you I have a spare one under the bench. email if you wish
I mean the actual power feed plate not the end plate

Although if its a new mill the holes should be there they locate on the centre hole and the two tapped holes


Stuart
Title: Re: Sieg X3 Table X-Axis End Plate Dimensions
Post by: No1_sonuk on May 09, 2011, 10:50:57 AM
PMed.

Would still be good if someone could share the info...
Title: Re: Sieg X3 Table X-Axis End Plate Dimensions
Post by: lordedmond on May 09, 2011, 11:19:29 AM
Check your P,M
Title: Re: Sieg X3 Table X-Axis End Plate Dimensions
Post by: lordedmond on May 09, 2011, 12:26:40 PM
in post Tue



Stuart
Title: Re: Sieg X3 Table X-Axis End Plate Dimensions
Post by: No1_sonuk on May 09, 2011, 02:58:08 PM
Thanks