MadModder
The Shop => Tools => Topic started by: bry1975 on November 05, 2010, 06:56:38 PM
-
Evening chaps,
So any of you chaps offer lathe turning services?
Cheers
Bry
-
I only turn light lathes, unless it's my go on the forklift :lol:
-
Whatcha looking for?
Eric
-
I am a bit far away being in Australia, but I am sure someone will help you out from over that way. :nrocks:
Like said above, it will help you out more if you could give a few details of the job at hand.
Dave
-
Thanks chaps,
At the moment am just after a watch bezel turned from 316L stainless steel.
The OEM bezel is fixed and clips into place but a replacement could be easily cemented into place.
Rough sizes are O.D 38mm I.D. 32mm thickness around 3mm.
I'll speak to the client but I think the chap would be happy to pay £20-£40 for the part.
Usually I refinish parts but this one has way to many dings/chunks whacked out of it, the watch looks like it has been repeatedly been banged and scraped against a concrete floor.
Please check images below:-
(http://img214.imageshack.us/img214/5456/tagwa.jpg)
(http://img210.imageshack.us/img210/1966/tag2y.jpg)
-
By the way if any of you chaps are fans of coated tools give me a shout as I'm always having parts PVD'D or DLC'D.
Tar
Bry
-
Hi Bry
Couldn't the bezel be mounted to a chuck and skimmed or stoned a little??
John..
-
Hi John,
Nar don't think so the bezel material is very thin on top.
-
Bry,
http://madmodder.net/index.php?topic=3783.msg41208#msg41208
Bogs