MadModder
The Shop => Tools => Topic started by: Stilldrillin on September 19, 2009, 12:53:39 PM
-
I thought there had to be an easier way, to make a small tap wrench. :scratch:
I was right! :thumbup:
Buy one of these.......
(http://i110.photobucket.com/albums/n95/Dayjo/p9190002.jpg)
Press the little black button and take off all these bits n pieces.....
(http://i110.photobucket.com/albums/n95/Dayjo/p9190004.jpg)
After turning the (soft) ratchet section away, polishing the 7mm shank & loctiting a little knurled flange......
Yer left with one of these......
(http://i110.photobucket.com/albums/n95/Dayjo/p9190008.jpg)
Works a treat! :clap:
(http://i110.photobucket.com/albums/n95/Dayjo/p9150014.jpg)
David D
-
Nice one David
At 3 squid fifty its a pinch or should we say a tap.
:lol:
Stew
-
David
Very nice little modification and cheap. :ddb:
Cheers :beer:
Don
-
Nice mod David
I think something like this is going to skip to the top of my round-to-it-list. Taps-I-Breakem.......
Need to go buy some new M6 taps first I suppose. Will look out for one of them.
Gerhard
-
A very nice addition David, bet it'll make tapping much less of a chore now..... :clap:
-
Thanks for your comments chaps...... :thumbup:
I used to use a chuck on a stick.
(http://i110.photobucket.com/albums/n95/Dayjo/p4110015.jpg)
But this small, proper tap wrench, is a great improvement. :D
David D