MadModder
Gallery, Projects and General => How do I?? => Topic started by: Darren on April 07, 2009, 11:54:11 AM
-
Can someone please explain what a pair of off-set centers are on a lathe,
I know what centers are, but how do you off-set them :scratch:
I would assume centers where centered and the work was off-set on the centers being driven by a dog?
-
Dunno! :scratch:
Crankshaft throws are turned between a pair of offset centre holes....... ::)
David D
-
Thanks David, I thought as much.
Was thrown by some text I was reading earlier.
Ta... :thumbup:
-
Yer welkum! :wave:
JUST read your Twin Cyl engine post. ::)
Good luck! :thumbup:
David.