MadModder
Gallery, Projects and General => Oooops! => Topic started by: Joules on April 15, 2017, 12:34:50 PM
-
YES !!!
(http://i.imgur.com/kb3Q6TX.jpg?1)
Within reason. To miss quote AvE, keep yer Dick away from my chucks...
-
not got a pin chuck then? :)
-
Nope, and I didn't want to get too close to that dangerous BIG chuck....
-
I reckon that you're showing off - flash b.....d with some many SHINY chucks :lol:
(also possibly a bit bored - time on your hands Joules ? )
-
Yeah, works gone quiet and the wife wanted these pin heads rounding off, only another few hundred more to go :ddb:
-
You really should get your slice of carrot cake.
You are not you, when you are hungry.
-
The big question is how true does it run :poke:
-
I wish I had so many chucks!! You defo need a pin vice :-)
Did it work or was this just for fun?
-
It's all "Tongue in Chuck" Chris. :thumbup:
-
Thats what the wood chuck said! :beer:
-
Sure you're not designing a mini pagoda :scratch:
George
-
The big question is how true does it run :poke:
I'm guessing any runout in the first 3 chucks can be addressed by the penultimate 4-jaw chuck, thus reducing TIR to something manageable. :headbang:
-
It's really good for resonance. Where as I used to get a poor finish at certain speeds and diameters. Now it's a crap finish at all speeds.
:lol:
-
If the drill chuck is too small to grip in the big three-jaw, wouldn't it be better to just wrap it in gaffer tape? :coffee:
Dave
-
If the drill chuck is too small to grip in the big three-jaw, wouldn't it be better to just wrap it in gaffer tape? :coffee:
How's it supposed to reach the workpiece then? Tsk, you haven't thought this through! :lol:
-
Within reason.
Spoken like a real modder.