MadModder
The Shop => Tools => Topic started by: smiffy on April 03, 2016, 06:28:00 PM
-
Had to make a new pin for a local farmers plough . 50mm dia and one end threaded 1-25 pitch on a reduced shank of 45mm. Material is EN24
So set my boley for semi auto screw cutting and this is a video of it working prior to cutting the thread.
The lathe has 2 micro switches on the bed operated by stops on the apron . As the tool approaches the end of its cut the spindle is electro mechanically braked and reversed at 4x the cutting speed , when it has fully returned the spindle is reversed and cut put on and a the processes repeats itself The lead screw is anti backlash and always engaged while screw cutting
There is no screw cutting gearbox but a large selection of gears and it can cut Metric Imperial Modular and DP pitches
-
Maybe this link will work
-
Having problems with the link if this does not work i=I give up
-
The third link works for me. Sweet lathe. Where did you end up getting it from?
Mark
-
Hi Mike
That is a glorious lathe, nice bit of work too.
best wishes
Mike
-
According to the Boley book I have spindle is a 3 Din 55 022 bored 4 MT and was available on request
-
Now I get it. :doh:
Size 3. (same as Camlock D1-3). I wonder how many different flavours of the KK short taper nose the germans came up with?
Certainly a better spindle nose than the threaded one.
Mark