MadModder
Gallery, Projects and General => Project Logs => Topic started by: Tinkering_Guy on July 19, 2010, 03:32:13 PM
-
Since Brass_Machine wanted a description (and more pictures) of the dice I made from a slice of nickel-iron (NiFe) meteorite, this looks like a reasonable place to start.
Here's one of the better pictures:
(http://source-zone.org/images/eBay/d6-01-01t.jpg)
I didn't record all the steps as I made them; this was one of my first projects, and it was half done on my UNIMAT-1 and half on my HarborFreight mini-mill. However, I can try to describe what I did, from memory.
The first thing was to get a meteor slice from eBay and slice off a section as wide as the slice was thick. I recorded some photos on Flickr, like
this one (http://www.flickr.com/photos/rous/1044098877/in/set-72157601287692588/).
After getting a long piece that was square in cross-section, I sliced it further into six cubes. For these operations I used a diamond saw, but have since learned to use cutoff wheels instead: "at high temperatures, carbon is essentially soluble in steel". In other words, the diamond grit was turning into carbon steel. Whee.
This is the point at which I moved to the mini-mill. I lined the six cubes up and milled them square (about 0.002 in each dimension, so they're obviously slightly thinner than the original slice), and used a #1 centre-drill to put in the pips. This was before I had DROs for the mill, so the pip positions were approximate.
I'd do things a little differently next time; that was a learning experience. I've sold two of the dice so far at US$100 apiece; I still have the other four, and intend to make still more.
And next time I'll take (and post) more photos.
-
Tinkering_Guy
Thanks for showing us that. Looks like a good way to make a couple of extra $$ to help pay for the mll and lathe. :ddb: :ddb:
Cheers :beer:
Don