MadModder

Home Base => Introductions => Topic started by: Edgwick one on July 04, 2015, 11:43:01 PM

Title: Hi from Perth Australia
Post by: Edgwick one on July 04, 2015, 11:43:01 PM

Hi to everyone I have joined your group. I have a very early Edgwick mark one lathe which I am in the process of re painting the original colour is grey with red levers. Also a milling machine and another lathe

Title: Re: Hi from Perth Australia
Post by: mexican jon on July 05, 2015, 12:16:51 AM

Hello And Welcome To A Great Forum  :thumbup: :thumbup:

Title: Re: Hi from Perth Australia
Post by: mattinker on July 05, 2015, 12:17:15 AM

Hello Edgwick One,

I already replied to your first post, but  welcome!

If you have any photos of your lathe, especially the threading instruction plate, I'd love to see them.

Regards, Matthew

Title: Re: Hi from Perth Australia
Post by: AussieJimG on July 05, 2015, 06:58:05 AM

Welcome from the other side of the country.

Jim

Title: Re: Hi from Perth Australia
Post by: krv3000 on July 05, 2015, 02:21:00 PM

hi and welcume

Title: Re: Hi from Perth Australia
Post by: howsitwork? on July 05, 2015, 05:09:39 PM

Hello and welcome from sunny North Yorkshire UK

Well it was sunny earlier - honest it was

Title: Re: Hi from Perth Australia
Post by: SwarfnStuff on July 06, 2015, 02:33:19 AM

Quote from: AussieJimG on July 05, 2015, 06:58:05 AM

Welcome from the other side of the country.

Jim

I second what Jim said and I'm down the bottom bit of this side just before you get wet, so you're welcome is covered from the Eastern side. Jim's a tad higher from memory - and possibly warmer at this time of year. This is a great place to hang out - enjoy, and above all have fun.
John B

Title: Re: Hi from Perth Australia
Post by: Meldonmech on July 08, 2015, 04:58:33 AM

 
   Hi
             Welcome to the forum, don't forget to post pictures of your lathe when it is finished, it sounds very interesting.

                                                        Cheers David