MadModder
The Craftmans Shop => New from Old => Topic started by: richburrow on May 12, 2011, 01:54:15 PM
-
I am planning to get a bigger gas bottle for my Mig so thought a trolley was in order. It will also keep everything together, people are making comments at work about how much storeroom space I use (hahahahahha screw them.)
Anyway it is an old cpu trolley/desk and has been getting in the way for a while.
Not any more.
(http://i724.photobucket.com/albums/ww242/richburrow/forum/Image0190.jpg)
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000524.jpg)
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000538.jpg)
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000542.jpg)
Put some propper wheels on it now, the original ones were duff plastic ones.
I am getting there, it takes ages because I only get half an hour here and an hour there. When it is done working will be much easier, I hope ::)
-
Good job! I really need to learn to weld...
Eric
-
:thumbup: lookin good Rich :dremel:
good bit of recycling :med: :D
Rob
-
Progress!!!!! :D
Added in a few extra bits for support
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000581.jpg)
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000582.jpg)
Found this in the store
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000583.jpg)
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000585.jpg)
Fully loaded
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000586.jpg)
Just needs a coat of paint now and I am done, well pleased :)
-
Torch holder is a good idea :thumbup: :thumbup: :thumbup:
-
A nice storage solution there, cant beat a bit of recycling, would like to recycle your statrite bandsaw a 352 i think into my garage if i had chance lol. notice the bench seems to be suffering from an attack of tenon saw itis, seems to be a universal complaint in the classroom.
-
Getting closer, I am pleased so far :D
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000605.jpg)
(http://i724.photobucket.com/albums/ww242/richburrow/forum/P1000606.jpg)
-
Nice, neat work. How much hassle is it to lift that bottle in and out of the corner?
-
Thanks TS, it is not too bad, that was a soloution that offered minimal hassle to assemble. The only thing that is a little irritating is I could scratch the paint on the way in and out. After a while and some use that wont be a problem anyway hahahaah. I need to get on and start using it now!!!!!!!!!!!
Cheers
Rich
-
Very tidy Rich :thumbup: :dremel:
Now what you going to make :poke: :poke: :poke: :poke: :whip: :whip: :whip: :)
Rob
-
Great looking rig. It will be easier to use now! :thumbup: