MadModder

Gallery, Projects and General => Oooops! => Topic started by: Dell on March 24, 2023, 10:28:50 AM

Title: Spot the mistake
Post by: Dell on March 24, 2023, 10:28:50 AM

I have been getting used to using my new to me lathe , I had already made a mount so I can use the graver, and I thought next I would make a carriage stop but it needed to be a stop and a mount for the dial gauge well I was chuffed that what I had made was going to do the job until I fitted the dti  :doh: the carriage hits the mount before the full travel of the dti , so a slight modification is needed.
Dell
 

 

 

Title: Re: Spot the mistake
Post by: awemawson on March 24, 2023, 10:42:40 AM

He who's never made a mistake has never made anything !

. . . . it's all a learning exercise  :thumbup:

Title: Re: Spot the mistake
Post by: AdeV on March 24, 2023, 12:51:34 PM

Could you make an extension for the DI plunger? Might be the easiest fix...

Title: Re: Spot the mistake
Post by: Dell on March 24, 2023, 04:01:21 PM

Yes AdeV
That was my thinking as extended pointers are freely available, although I could make one.

Title: Re: Spot the mistake
Post by: krv3000 on June 10, 2023, 03:09:26 PM

 hi a job well dune just make a extension  regards bob