MadModder

Gallery, Projects and General => Gallery => Topic started by: capjak on March 04, 2010, 02:15:49 PM

Title: River Queen Open Column Launch Engine
Post by: capjak on March 04, 2010, 02:15:49 PM
I just completed this engine and it runs! It is built from plans that were published by the Edelstaal Technical Institute in 1972. I downloaded them quite a while ago but I don't remeber the source. Based on the information in the booklet that came with them, this was a kit that was marketed to owners of Unimats. It has a 1/2 inch bore and a 5/8 inch stroke. So far I have been able to run it on 20 pounds of air pressure. All of the machining was done on a Smithy 3in1 machine. With the exception of the 3/16 CRS rod used for the columns and crankshaft and the brass tubing, all of the other materials were pieces of scrap of dubious parentage. The only real problem that I had was when I broke a tap in the final hole in the cylinder. I annealed the brass pipe and then bent it in a jig that I made out of wood. All in all, it was a fun project. I will post some pictures of the work while it was in progress and a video as soon as I learn more about how to use Photobucket and my camera.

I spend about two hours a day on this board and Home Model Engine and read all of the posts. I can't thank the people enough who have given their time and energy to these sites. I have learned so much. I feel both inspired and intimidated by the projects that I have seen. These are the best sources of information that I have found.

Thanks to all,

Jack

(http://i1008.photobucket.com/albums/af204/capjak/River%20Queen%20Engine/March4010.jpg)

(http://i1008.photobucket.com/albums/af204/capjak/River%20Queen%20Engine/March4007.jpg)
Title: Re: River Queen Open Column Launch Engine
Post by: dsquire on March 04, 2010, 03:04:54 PM
Capjak

:ddb: :ddb: WE HAVE A RUNNER  :ddb: :ddb:


Congratulations Jack on getting your engine completed and running. I can just about imagine the big grin on your face when it ran for the first time. I am glad to hear that reading the posts has helped you with your build. I am sure I speak for everyone when I say that we look forward to a video when you get the camera/photobucket figured out. Have you given any thought to what your next project might be?  :D :D

Cheers  :beer:

Don
Title: Re: River Queen Open Column Launch Engine
Post by: Brass_Machine on March 04, 2010, 03:05:50 PM
Nice engine Jack!

No need to feel intimated... inspired yes! My talents are lacking, but I see what I can/could do if I put my mind to it....

Thanks for the kudos about this site. It is the membership that makes it what it is! That includes you.

Eric
Title: Re: River Queen Open Column Launch Engine
Post by: Brass_Machine on March 04, 2010, 03:06:33 PM
Oh yeah... 1st running engine?? we need a video so we can share the grin!!   :D :D

Eric