MadModder
The Craftmans Shop => PowerSports => Topic started by: doubleboost on March 02, 2011, 05:00:41 PM
-
A feiend of mine is building a hybrid ford engine for a sprint car
It is a 2 litre zetec block bored out to 2.1 with a ford cvh head and turbo bolted on top
Anyway after he plied me with drink i agreed to do his water pump and tensioner mods as well as some big crank case drains.
My machine tools are not small but this took some fiddling with
(http://i261.photobucket.com/albums/ii63/john970s0/P3020065.jpg)
would not go under the mill or the ped drill
not high tech but pop crates are very square
(http://i261.photobucket.com/albums/ii63/john970s0/P3020068.jpg)
breather hole
(http://i261.photobucket.com/albums/ii63/john970s0/P3020073.jpg)
the hole was a bit on the big side so i made a expander
(http://i261.photobucket.com/albums/ii63/john970s0/P3020075.jpg)
that wont leak or drop out
(http://i261.photobucket.com/albums/ii63/john970s0/P3020080.jpg)
pump & tensioner in place
-
Nice job!. Why did the water pump and tensioner need mods?
Eric
-
So Thats what you have been up to John :clap: :clap: :clap: :clap: :clap: :clap: :dremel:
Rob :D