MadModder

Gallery, Projects and General => How do I?? => Topic started by: hogman on November 15, 2020, 06:26:50 PM

Title: after about 60 minutes tool path goes awry using ddsc2.1 controller
Post by: hogman on November 15, 2020, 06:26:50 PM
Hi,
Today spindle moved to next part and took a Z dive. Code is good, operation sims well yet for some reason Z went wrong. Other ways it can go off is slowing way down and taking a wrong path.

I have seen this happen during an op that has been running awhile. I use a digital dream 2.1 offline controller. I do recheck the code and it is always fine.

Any ideas why this happens and how to fix. ? Please suggest another controller if wise. I do not want to run a pc tho.
Title: Re: after about 60 minutes tool path goes awry using ddsc2.1 controller
Post by: russ57 on November 16, 2020, 04:47:55 AM
Overheating?

-russ

Title: Re: after about 60 minutes tool path goes awry using ddsc2.1 controller
Post by: hogman on November 16, 2020, 07:57:27 AM
may be. I will change mount today to open up vents in back of unit. Thank you