MadModder
Gallery, Projects and General => Member Videos => Topic started by: celsoari on September 27, 2019, 03:34:09 PM
-
I was just wanting to build one, I hope you enjoy the video
Celso Ari
-
Very nice tool post!
-
Good work
-
Nicely done!
I'm curious though - why didn't you rough out the dovetails on the shaper? Seems it would have been perfect for that job, and a lot less stressful than trying to keep the dovetail cutters in good condition which, as I found when I did my QCTP & toolholders, means lots of slow tedious light cuts...
I plan to make more toolholders for mine, and I'll definitely be doing them on the shaper!
-
Nicely done!
I'm curious though - why didn't you rough out the dovetails on the shaper? Seems it would have been perfect for that job, and a lot less stressful than trying to keep the dovetail cutters in good condition which, as I found when I did my QCTP & toolholders, means lots of slow tedious light cuts...
I plan to make more toolholders for mine, and I'll definitely be doing them on the shaper!
73/5000
I don't have much shaper skill yet.
I am learning to use it
greetings from Brazil
Celso Ari
-
Very nice work!!
Phil
East Yorkshire
UK.
-
Very nice work!!
Phil
East Yorkshire
UK.
Thaks bro
greetings from Brazil
Celso Ari