Recent Posts

Pages: 1 [2] 3 4 ... 10
11
Member Videos / Re: My week this week, my workshop videos!
« Last post by awemawson on April 04, 2024, 11:24:22 AM »
Glad you are clear of the dreaded Covid Phil. I went today for my Shingles jab - had Shingles end of last June and still have some annoying symptoms. Needs a booster in a few weeks which is odd as my wife had the jab a few months back and no followup required.
12
Member Videos / Re: My week this week, my workshop videos!
« Last post by hermetic on April 04, 2024, 06:53:49 AM »
Good news! I have today tested negative for covid, so will go back to the workshop to carry on installing the new heating next Monday! Normal service will be resumed on the following Saturday at 4PM! Feeling a lot better but still got the hangover cold that my brother was suffering from  when I caught it off him.......maybe, who really knows!
Thanks for your patience!
Phil
13
Electronics & IC Programing / Re: Pi PICO DRO/Quill-Knee combiner
« Last post by BillTodd on April 03, 2024, 02:45:49 AM »
Thanks James  ,

They said ' bypass' , I was thinking flyover and round-about .
14
Project Logs / Re: Steady for Harrison
« Last post by BillTodd on April 03, 2024, 02:42:37 AM »
Looks up to the job phil nice :clap:
15
Project Logs / Re: Steady for Harrison
« Last post by philf on April 02, 2024, 04:23:07 PM »
Brill!
16
Project Logs / Re: Steady for Harrison
« Last post by shipto on April 02, 2024, 01:01:09 PM »
Apart from a better nut which with everything else I need to do is unlikely to get done thats it finished.  :ddb:
17
Electronics & IC Programing / Re: Pi PICO DRO/Quill-Knee combiner
« Last post by JamesC on April 02, 2024, 05:56:49 AM »
Hope it goes well Bill and you make a spedy recovery
18
Project Logs / Re: Steady for Harrison
« Last post by shipto on March 31, 2024, 04:17:39 PM »
Got it to a place where I can make some cuts with it, I need to get some paint for it and work out a better clamping method to hold it in place but other than that I am calling it a success.
19
Member Videos / Re: My week this week, my workshop videos!
« Last post by hermetic on March 31, 2024, 08:05:46 AM »
Sorry guys, no video thiis week, awoke with covid on monday morning, much better now, but still not work fit! Hope to get back on Tuesday!
Phil
20
Electronics & IC Programing / Re: Pi PICO DRO/Quill-Knee combiner
« Last post by BillTodd on March 31, 2024, 08:05:24 AM »
Gonads!

This project will be paused while the damage done by demon is surgically repaired.

...

Pages: 1 [2] 3 4 ... 10