MadModder
Gallery, Projects and General => Gallery => Topic started by: Aestus57 on August 10, 2011, 07:55:24 AM
-
Hi Folks,
Yes, I know its not the first one to be featured here, but I'm still quite proud of her... Getting one to run will just spur me on to bigger and better projects.
Any sugestions for the next one will be most welcome.
:mmr:
-
It's a good start :D
-
Nice little runner. :thumbup:
Looks like one of Elmers engine. How about a twin cylinder for the next one?
Bernd
-
Aestus57
Sure looks like fine little runner to me, especially for a first engine. As Bernd said, a twin might be a good choice for your next engine. I am sure there will be a few others along with other suggestions. Thanks for showing it to us. :D :D
:nrocks: :nrocks:
Cheers :beer:
Don
-
Nothing beats the satisfaction of your first runner bursting into life. A great little runner.
Yes a twin oscillator could well be your next step. Take a look at Elmers #2 plans available at http://www.john-tom.com/ElmersEngines/02_twinVwobbler.pdf (http://www.john-tom.com/ElmersEngines/02_twinVwobbler.pdf).
John-Som
-
That's a good 'un! :thumbup:
Well done...... :clap: :clap:
David D
-
That's very nice, runs well. :thumbup: :clap:
I like wobblers :D
:beer:
DaveH
-
Very nice little engine, and definitely something to take pride in! :beer:
Cheers
Jeff
-
Elmers #25 was my 1st engine too. Your's looks much better. Nice Job.
-
Nice job :clap: :clap:
You have made a living thing from nothing :bugeye: :bugeye:
John
-
Nice work! Elmers #25, it was my second engine build and yours looks better than my efforts as well!!
-
Really nice. A little oscillator is next on my list.
-
well dun :)
-
Good Job That Man
:clap: :clap: :clap: :clap: :clap: :clap: :clap:
Stew
-
I'm a little late to this build, but nice job !!
I built the little wobbler from Sherline's Table Top Machining book, the "Millie" Took a little tweaking but runs like a champ now !!
Mike