MadModder
The Breakroom => Resources => Topic started by: PTsideshow on May 11, 2008, 05:00:16 PM
-
http://www.powdercoatoven.4t.com/ (http://www.powdercoatoven.4t.com/)
-
I have this guys plans saved. Currently I have a house range that I use to bake my powder... just a standard 220v GE type of oven. I am going to tear it apart and build on like his as soon as my welding skills improve (well as soon as I get welding skills)
Eric
-
Thanks for all the links! This one is great!
Wes
-
Thanks for all the links! This one is great!
Wes
Wes,
Do you do any powder coating?
Eric
-
Yes. We powdercoated some of the parts on my wifes CB and a few pieces on my KZ.
Wes
-
Very cool indeed. What are you using for a gun? I have a very cheap one... the HF version. It does an OK job, but I am going to get the Eastwood to replace it.
Eric
-
At one point in time horrible fright and eastwoods were selling the guns. you may also want to check out caswell I put ta link to it they sell the powder coating stuff also.
-
At one point in time horrible fright and eastwoods were selling the guns. you may also want to check out caswell I put ta link to it they sell the powder coating stuff also.
I am familiar with the Caswell's site. Got a lot of good info and stuff there. I actually bought my gun off of ebay... same one that HF sells. A co worker got the cheap eastwood gun... it does a much better job than my HF gun. But since I am not doing any coating for retail... only small pieces it will do ok for awhile.
Eric
-
This is my vice stop I built and coated:
(http://madmodder.net/Shop/Vice%20Stop%201.JPG)
Eric
-
It looks good. I will admit I haven't been on a motorcycle in close to 30 years but it still looks good.