MadModder

Home Base => Introductions => Topic started by: koduk on December 22, 2023, 09:51:14 AM

Title: Introduction message
Post by: koduk on December 22, 2023, 09:51:14 AM
Good morning all.
I'm a newbie to this forum, it could be said I'm a newbie to all forums.
To say the least,this post is probably at the wrong place.....but that is the only place I have found where there is a place to write my introduction.
Any help will be appreciated.
koduk
Title: Re: Introduction message
Post by: John Rudd on December 22, 2023, 10:24:15 AM
Koduk,

Welcome, plenty of folk on here willing to help inc me.


Just ask away…any thing you got in mind?
Title: Re: Introduction message
Post by: howsitwork? on December 22, 2023, 04:15:54 PM
welcome aboard Koduk
Title: Re: Introduction message
Post by: koduk on December 23, 2023, 12:06:53 PM
Good morning M.Rudd.
Well it seems I posted without knowing at the proper place....goood! This is the very same place I had found to post that I am using presently.
Okay, here I go. I am a 78 years old French Canadian with varied interests in, repairing, modifying, building, and rebuilding tools and everything else including cultivating my garden. You could say "an old man using with amusement is talents".
 As an example, quite by luck, while googling for a method of localising underground plastic pipe, came upon an article by AWEMAWSON on how he built himself a "water thumper" I could make good use of for repurposing my irrigation system.
Not being able to send an email directly to him, I picked up the MadModder.com name and registered. This morning, with your answers I will try to obtain further informations
 Thank you M.Rudd.
Title: Re: Introduction message
Post by: Dell on December 27, 2023, 10:32:59 AM
Welcome Koduk
Title: Re: Introduction message
Post by: koduk on December 27, 2023, 01:21:58 PM
Good afternoon.
I have to offer recognition to: howsitwork? and Dell for there welcoming me aboard.
Just as a note to John Rudd, the aircraft on your avatar is called a "Harvard" here in Canada and AT6 Texan, and SNJ6 in USA, in my very earlier years I had to work on one of them, Iv'e also been an EAA member until TRUMP and I have quit since.
Thanks for your help M.Rudd, iv'e succeeded to get in contact with AWEMAWSON.
It is much fun being on a forum
Thank you all