MadModder
Gallery, Projects and General => Gallery => Topic started by: Bishop on May 30, 2014, 11:44:39 AM
-
(http://s11.postimg.org/uycafeutv/image.jpg)
(http://s14.postimg.org/5sc2uwzqp/image.jpg)
Shawn
-
Nice work Shawn - if I had a decent compressor I`d buy one of these pencil grinders for my workshop and give it a go on my CNC.
Chris
-
Thanks Chris, your right about needing some decent air, even my bigger compressor is barely enough to run the grinder. I had another go today and I think my first results were compromised by a loose collet. I tightened the collet up and got much better results this morning.
(http://s2.postimg.org/oly3vwzih/image.jpg)
Shawn