91
Project Logs / Re: Steady for Harrison
« Last post by philf on March 16, 2024, 09:41:07 AM »As for the pins this is my first thoughts.
The end of the highlighted shaft will be threaded to secure them in place which will be set by a number of spacers I can put either side dependent on the stock I am turning. The keyway will allow me to fully tighten it without it turning.
Inside will be a sprung brass bar with a screw to set it against the stock.
I assume that the spring is just there to stop the insert falling out?
How much adjustment will you have before needing to swap spacers?