MadModder

The Shop => Our Shop => Topic started by: norman on November 24, 2011, 06:41:20 PM

Title: My Grizzly Mill G0619
Post by: norman on November 24, 2011, 06:41:20 PM

I bought the mill 10-21-2011. I built the stand from 2" sq. tubing.For the mill added a table power feed and a Dro Pros  electronica el400 dro. This is quite a big change from the Gingery metal mill I built, which now lives on the bottom of the mill stand ready for use if I happen to want to use it.
(http://i265.photobucket.com/albums/ii237/leonane/DRO/100_0159.jpg)


You can just see the G0602 lathe to the left and the Sears 6" lathe behind the mill.

here's the start of the stand
(http://i265.photobucket.com/albums/ii237/leonane/mill%20stand/100_0105.jpg)
finished stand with most of my toys close by.
(http://i265.photobucket.com/albums/ii237/leonane/mill%20stand/100_0137.jpg)

Title: Re: My Grizzly Mill G0619
Post by: Bernd on November 24, 2011, 07:05:20 PM

A very well and nice organized shop if I may say so.

I was orginally going to get that mill next that you have, but instead found a nice Bridgeport instead. It now resides in my basement.

Bernd