« previous next »
Pages: [1]   Go Down

Author Topic: Tap Wrench Tip  (Read 2800 times)

Offline Meldonmech

  • Hero Member
  • *****
  • Posts: 933
Tap Wrench Tip
« on: August 22, 2014, 05:53:05 AM »
 
    Hi Guys

                    When I come to tap small holes requiring delicate torque, I use a combination clock key as a tap wrench.  The key I   use is for no. 2- 4- 6- 8- 10  clock winder squares.  This fits no. 6BA to 0 BA taps.

                                                                    Cheers David
Logged

Offline Stilldrillin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4972
  • Country: gb
  • Staveley, Derbyshire. England.
Re: Tap Wrench Tip
« Reply #1 on: August 22, 2014, 07:38:16 AM »
Logged
David.

Still drilling holes... Sometimes, in the right place!

Still modifying bits of metal... Occasionally, making an improvement!

Offline Meldonmech

  • Hero Member
  • *****
  • Posts: 933
Re: Tap Wrench Tip
« Reply #2 on: August 23, 2014, 10:35:29 AM »
 
    David I found a key under 'Clock Spider Key Brass' on eBay, sizes 2,4,6,8,10 for £ 2 . 90 post free from  redroosteruk.

                                                      Very Reasonable

                                                                                 Cheers  David
Logged

Offline Stilldrillin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4972
  • Country: gb
  • Staveley, Derbyshire. England.
Re: Tap Wrench Tip
« Reply #3 on: August 23, 2014, 05:13:00 PM »
Very reasonable, David!  :thumbup:

David D
Logged
David.

Still drilling holes... Sometimes, in the right place!

Still modifying bits of metal... Occasionally, making an improvement!
Pages: [1]   Go Up
« previous next »