Gallery, Projects and General > Project Logs
X axis drive
<< < (2/2)
Bluechip:
That looks fine, George  :thumbup:

Just a general purpose switch mode supply. I was a bit concerned you described it as a 'transformer' which is just AC in and AC out ... As you were, carry on ... just ignore me ...  :lol:

Dave
mechman48:

Test running X axis drive...

Bigbadbugga:

I like that, runs real smooth. :clap:
BaronJ:
Hi George,

I've built a couple of mill table drives using wiper motors !  If you have it wired correctly they are very hard to stall.
At the moment I am using a 30 volt @ 3 amp variable power supply.  Neither motor takes more than a couple of amps at 12 volts.  My two motors are slightly different.  One uses the motor case as one of the connections and I suspect that is what you have.  If you feed power to the two wires the motor will rapidly get hot and won't produce a lot of torque.  One wire will give you low speed and the other will give you high speed.

I do have photographs but they are on another computer that I don't have access to at the moment.  Or you can check out this link.

 http://www.woodworkforums.com/184913-table-traverse-chinese-mill/

You will have to register to view the pictures.  But you will also be able to read the whole thread about both table traverse builds.



Navigation
Message Index
Previous page

Go to full version