Gallery, Projects and General > Project Logs
Only a Little-Oil-Seal !
<< < (6/10) > >>
awemawson:
So all keen and enthusiastic I made a few mods to my bearing separator - essentially just longer spacers and a longer bridge piece and went at it.

End result - no movement  :bang: Tried all the tricks - warmed the race up, gentle taps when under pressure - nowt, zilch, nothing

So I need to find a bigger separator - this one is supposed to do up to a 75 mm bearing inner race but doesn't really have either the beefyness or the spread.
awemawson:
Received wisdom seems to be to cut the bearing off with a disk cutter and replace - apparently they are notorious for their reluctance to move according to my local agricultural engineer. New bearing on order
vtsteam:
Irritating.

Leave the pressure on with penetrating oil applied for a few days, tapping lightly, and guaranteed, it will pop loose ten minutes after you have the new bearing in hand!
awemawson:
You are probably right Steve - that's life !

Spent a little time today making up a timber cradle to make putting it back on the tractor a little easier - seems to work - I did a trial 'offering up'

vtsteam:
Good thinking!  :thumbup: :clap:
Navigation
Message Index
Next page
Previous page

Go to full version