| Gallery, Projects and General > Gallery |
| DIY Way vocer for the mill - fast and easy ! |
| (1/1) |
| ksor:
Another Little project for a rainy day here in Denmark Look here: http://kelds.weebly.com/way-cover-for-the-mill.html :palm: |
| vtsteam:
When my way protector for my round column mill/drill cracked, I replaced it with a piece cut from a flexible clear automotive floor mat. It looks works very well, and I can see the ways through it in case anything does get past. The floor mat was generic, and quite inexpensive, and there's enough material left over to do other machines. |
| Arbalist:
My mill came with a thick rubber protector that kept getting in the way so I replaced it with some much thinner reinforced rubber sheet that normally resides inside some of the larger Photocopiers. Much better! |
| tom osselton:
I'm thinking of doing the same for the lathe I'm turning cast so it would give the ways much more protection. |
| Navigation |
| Message Index |