| Gallery, Projects and General > How do I?? |
| Remove Seized on chuck ?? |
| << < (15/16) > >> |
| chipenter:
Tony at lathes.co.uk has backplates on stock for £65 . |
| doubleboost:
The register is the bit that gives the chuck / face plate ect its accuracy The thread can be slack (ish) I have a drive plate that wobbles up the thread but always runs dead true once tight John |
| awemawson:
I think John Stevenson's point was that even a thread that wobbles as you describe when not under tension will pull itself concentric when tensioned. |
| Manxmodder:
--- Quote from: chipenter on June 09, 2014, 04:22:09 PM ---Tony at lathes.co.uk has backplates on stock for £65 . --- End quote --- If that price is for a cast iron blank that needs machining then it is very expensive. I think I'd be sourcing a piece of steel bar butt end or looking for a suitably sized car flywheel from the scrappy than pay that.....OZ. |
| stig:
if its just a blank then they're available far cheaper off evilbay smaller item in link below as example http://www.ebay.co.uk/itm/300921529064 |
| Navigation |
| Message Index |
| Next page |
| Previous page |