The Craftmans Shop > PowerSports

A loader for the Ford 850 from bits and pieces

<< < (8/14) > >>

vtsteam:
Then they were welded:

vtsteam:
And the welds ground back:

vtsteam:
Working alone outside on uneven ground, it was really tough to get the arms aligned so they could slide together. Quite a struggle! The bottom was not only heavy, but unbalanced -- lifting one tube tended to swivel the other. You can see the heated and bent tie rods in this photo -- they would have made fitting the arms even harder if left straight. But finally I got the far tube started.
Phew!  :Doh::

vtsteam:
Going together:

vtsteam:
We're there!!  :ddb:

Navigation

[0] Message Index

[#] Next page

[*] Previous page