| Gallery, Projects and General > Project Logs |
| Mogas makes something. |
| << < (2/3) > >> |
| Mogas:
Center punch the holes. |
| Mogas:
Tap to M3 I used the drill chuck with a center in it to keep that little tap straight. |
| Mogas:
Result! Just a note: When I tried the tool, I found that there was not enough relief angle on the carbide tip when offered up to the job. The M3 screw was slackened off and a .4mm shim made out of old crate strapping inserted, giving just the right relief. A little cleaning up with a file and the end result is a sturdy set of tool holders. Over all, a very satisfying exercise! :thumbup: |
| Brass_Machine:
Good job Mogas. I am going to attempt this in the not too distant future. Thanks! Eric |
| sbwhart:
Nice one :thumbup: I'm shure this will be usful to the chaps. Stew |
| Navigation |
| Message Index |
| Next page |
| Previous page |