The Craftmans Shop > PowerSports
1954 Ford 850 Tractor w/blown Head Gasket (at the very least)
vtsteam:
--- Quote from: mattinker on May 22, 2014, 12:54:23 PM ---
--- Quote from: vtsteam on May 22, 2014, 09:42:03 AM ---
I guess if I do end up tryi ng to make another cap, the trick will be the .350" bore and flat face inside. Might have to actually make a rose cutter or something to cut that.
--- End quote ---
Make a miniature boring bar. The flat bottomed hole, use a modified two flute end mill as a boring bar, face off the bottom of the hole from the centre.
Regards, Matthew.
--- End quote ---
Maybe just a homemade square ended D-bit would do it, after drilling undersized?
It's raining and will for a couple days, and I've called the traactor guy twice with no answer. Seems like a perfect rainy day project....
awemawson:
Here you go Steve, no special tooling needed at all:
http://madmodder.net/index.php/topic,9466.0.html
mattinker:
--- Quote from: vtsteam on May 22, 2014, 01:38:30 PM ---[
Maybe just a homemade square ended D-bit would do it, after drilling undersized?
It's raining and will for a couple days, and I've called the traactor guy twice with no answer. Seems like a perfect rainy day project....
--- End quote ---
Or a drill bit ground straight!
Regards, Matthew
vtsteam:
Great tips! :thumbup:
Too late! I had already headed out to the shop and started to make an olde tyme slot drill. :dremel:
Now I want to see if it will work! :zap:
Turned the endd of some half inch drill rod to .350"
vtsteam:
Relieved both sides to leave a .100" thick piece (fake metric) :
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version