The Craftmans Shop > PowerSports

1954 Ford 850 Tractor w/blown Head Gasket (at the very least)

<< < (7/28) > >>

Manxmodder:
Looking good Steve,it doesn't look out of proportion to the taper shank and the inertia when running will help with the finish on the head skim.
Look forward to seeing it in action.....OZ.

vtsteam:
Wow Oz, your post came in just as I was opening up a reply to post some of today's photos!  Well, here goes:

I slotted the rim to take one of my inserts, and then used a tansfer punch to mark the hole location for a retaining screw, drilled and tapped that 8-32:

vtsteam:
Here's the fly cutter mounted and ready for a test run:

[/URL]

vtsteam:
To test it out and give it an interrupted cut on a tough subject to chew, I decided to face this raw CI sand casting I made last summer:

vtsteam:
I started on the back first to get it roughly parallel to the face:

Navigation

[0] Message Index

[#] Next page

[*] Previous page