Gallery, Projects and General > How do I??

Enlarging Holes in Thick Plate

(1/10) > >>

awemawson:
I need to enlarge some 22mm mounting pin holes in my Twose 276 Hedge cutting Flail to take 1" pins

This is the Flail:

awemawson:
And these are the mounting lugs with the holes in question:

RussellT:
Turn some bushes for the holes on the tractor.

Russell

porker:
Just lift it onto the mill and bore....

But seriously I think this is a job for a mag drill I would have thought. Don't know how accurate they are though so you may need to drill oversize and make some bushes.

tekfab:
Do you have access to a mag drill ? If you're careful at the start then it'll do it no problem.  If you're not confident then you can tack weld a plate behind the hole to locate the spring centre.
Mike

Navigation

[0] Message Index

[#] Next page