| Gallery, Projects and General > How do I?? |
| Enlarging Holes in Thick Plate |
| (1/10) > >> |
| awemawson:
I need to enlarge some 22mm mounting pin holes in my Twose 276 Hedge cutting Flail to take 1" pins This is the Flail: |
| awemawson:
And these are the mounting lugs with the holes in question: |
| RussellT:
Turn some bushes for the holes on the tractor. Russell |
| porker:
Just lift it onto the mill and bore.... But seriously I think this is a job for a mag drill I would have thought. Don't know how accurate they are though so you may need to drill oversize and make some bushes. |
| tekfab:
Do you have access to a mag drill ? If you're careful at the start then it'll do it no problem. If you're not confident then you can tack weld a plate behind the hole to locate the spring centre. Mike |
| Navigation |
| Message Index |
| Next page |